SCFF 1-TRX 10G & 25G NRZ (RUGGED)
Size, efficiency & versatility all the way to 28 Gb/s

The rugged SCFF ("Small Cubical Form Factor") is a 1-channel duplex multi-mode (850nm) on-board transceiver with a 12pin electrical interface (SMT) complying  specification SFF-8431 for high speed interfaces. 

It operates at data-rates up to 25Gbps in harsh environment:

• Operating case temperature: (-40°C;+85°C)
• Shock: (500g;1ms) per MIL STD-883 Method 2002.4
• Vibration: 20g@[20-2000Hz] per MIL STD-883 Method 2007.3

The SCFF series has first been introducted in 2009 for 10Gbps speeds. A new rugged version of the SCFF has been developed by AAOP in 2019 to answer the needs for increased data-rates (25Gbps) and harsh-environment applications. The rugged SCFF is a “chip-on-board” transceiver leveraging state of the art 25Gbps chipsets from the data-com industry (VCSEL drivers, TIA, VCSEL, PIN Diodes).

The rugged SCFF is mounted on a PCB using two screws and is solder-mount on the rear connector. Its height has been optimized to be lower than 10mm above the PCB to fit the state-of-the art electronic casings.

PART NUMBER SELECTION:

• Order now at marketing@amphenol-aop.com
• For STEP file please contact us.

FEATURES:

• Small Cubic Form Factor (SCFF): half the area of an SFP+
• Data rate transparent from 1.25Gbps to 28.05Gbps*
• Duplex LC optical interface 
• SFF-8472 compliant two-wire control and diagnostic interface (i²c)
  • Tx Power monitoring
  • Temperature monitoring
  • Input voltage (module)
  • Rx Power monitoring (RSSI)
  • Bias current monitoring
  • Programmable input equalization
  • Programmable output amplitude and de-emphasis
• Enhanced Bit Error Rate (1e-12) requires no or limited FEC
• Programmable input equalization
• Programmable output amplitude and de-emphasis
• Clock and Data Recovery*
• High link-budget (14dB nominal at 10 Gbps)

BENEFITS:

• Uses 2x less board space than SFP+ form factor
• Supports standard and non-standard protocols in this range of data rates (10GbE, 25GbE, 8G/16G/32G Fiber Channel…)
• Ideal for applications requiring safe optical connection
• Allows for transceiver optimization and monitoring connection discovery, channel diagnostics, and signal status monitoring
• Lower system latency and better system performance
• 16dB of signal peaking at 14GHz to compensate for suboptimal signal condition*
• Compensate for PCB traces loss for proper signal conditioning
• Guaranteed performance over full data rate range
• Low power consumption (<0.45W at 10Gbps [0°;+85°C] Tx+Rx)

* for 25Gbps version only